返回列表 回復 發帖

發動機油管與螺旋槳的安裝

安裝
1. 發動機油管連接。由於油箱內有高壓,仔細緊密連接油路。必須防止在壓力下單向閥洩漏和管路扭結。
2. 允許使用燃料過濾器。我們建議使用YS燃料過濾器。
3. 圖1上單向閥標示方向,箭頭指向油箱。
-----------------------------------------------------------------------------

PROPELLER INSTALLATION
Due to the high torque of the FZ63 engine, we have equipped it with
a double lock system for safety.
1.Mount the propeller and tighten the rear nut. Next, tighten the front
nutas shown in Fig.1.
2.Select a good quality propeller that will turn in the 9,000 to 12,000
rpm range. We recommend sizes 11x7-11x9,12x6-12x8.

螺旋槳的安裝
由於FZ63發動機扭力大,我們為了安全採用了雙螺母鎖緊機構。
1. 安裝螺旋槳並擰緊後螺母。其次,擰緊前螺母如圖1所示。
2. 選用適用於9000到12000rpm速度的高質量螺旋槳。我們建議使用螺旋槳規格為
11×7-11×9,12×6-12×8。
-----------------------------------------------------------------------------

START UP
1. Remove tube B from the filter: remove tube A from the check valve,then
fill the tank. (CAUTION: If tank is filled or under pressure remove
tube A first, then tube B. Fuel will eject if tube B is removed while the
tank is pressurized. )
2.Open the needle valve 2 l/2 turns from the fully closed position.
3.Open the throttle fully and slowly turn the propeller 10 times. This
primes the system by pressurizing the tank and sending fuel to the
carburetor.
4. Close the throttle to the idle position and connect the glow plug battery.
The engine is now ready for starting.
DO NOT ATTEMPT TO START FULL THROTTLE,
AS THIS IS VERY DANGEROUS.
返回列表